User Guide

7 Unplug the pickup-sensor connector (callout 6), and then remove six screws (callout 7)..

Figure 6-80 Tray 1 pickup assembly (3 of 4)

Reinstallation tip One of the screws on the left side (callout 7 in Figure 6-80 Tray 1

pickup assembly (3 of 4)) is longer than the other screws. Make sure that this screw is

replaced in the hole from which is was removed.

CAUTION Carefully thread the solenoid wire-harness through the hole in the chassis.

When you remove the pickup assembly, avoid pinching the pickup solenoid wire-harness

between the assembly and the chassis.

Pickup and feed assemblies 259