User Guide

8 Rotate the left side of the assembly away from the chassis, and then slide the assembly to the
left to remove it. Carefully feed the pickup-assembly-solenoid wire-harness through the opening
in the chassis as you remove the assembly.
Figure 6-81 Tray 1 pickup assembly (4 of 4)
Reinstallation tip Reroute the solenoid wire-harness through the opening in the chassis.
Reinstallation tip When you install the pickup assembly, verify that the grounding
spring (located on the right-side of the assembly near the drive gear) is correctly
positioned against the dimple in the chassis.
Figure 6-82 Correct position of the tray 1 pickup assembly grounding spring
260 6 Removing and replacing parts