User Guide

4 Remove seven screws (callout 4) and then remove the bracket (callout 5). Slide the spring-gear
assembly (callout 6) away from the chassis until the gear shaft clears the hole in the chassis, and
then slide the assembly towards the rear of the feeder to remove it.
5
6
4
Figure 6-129 1,500-sheet feeder lifter-drive assembly (2 of 4)
5 Release the lifter-gear shaft-collar locking pin and rotate the collar until the inner locking tabs
align with the corresponding holes in the bracket. Slide the collar off of the shaft.
Figure 6-130 1,500-sheet feeder lifter-drive assembly (3 of 4)
298 6 Removing and replacing parts