User Guide

Control panel message Description Recommended action
LOAD TRAY XX
<TYPE> <SIZE>
For help press
alternates with
LOAD TRAY XX
<TYPE> <SIZE>
To use another
tray press
Tray XX is either empty (based on the
operation of the paper sensor) or
configured for a type and size other than
that specified in the job.
1
Press
( H ELP button) for detailed
information.
2
Press
( U P A RROW button) and
(D OWN A RROW button) to step through
the instructions.
3 Print a configuration page and verify
that the tray settings are correctly set.
See
Configuration page.
4 If the tray settings on the configuration
page do not match the actual tray
setting, verify that the paper width
switch (SW102, SW801, or SW1) is
operating correctly for the indicated
tray. See Printer switches and sensors,
500-sheet feeder switches, sensors,
solenoids, and PCAs, or 1,500-sheet
feeder switches, sensors, solenoids,
and PCAs.
LOAD TRAY XX
<TYPE> <SIZE>
For help press
Tray XX is either empty (based on the
operation of the paper sensor) or
configured for a type and size other than
that specified in the job. No other tray is
available.
1
Press
( H ELP button) for detailed
information.
2
Press
( U P A RROW button) and
(D OWN A RROW button) to step through
the instructions.
3 Print a configuration page and verify
that the tray settings are correctly set.
See
Configuration page.
4 If the tray settings on the configuration
page do not match the actual tray
setting, verify that the paper width
switch (PS106, SW801, or SW1) is
operating correctly for the indicated
tray. See Printer switches and sensors,
500-sheet feeder switches, sensors,
solenoids, and PCAs, or 1,500-sheet
feeder switches, sensors, solenoids,
and PCAs.
Lower the optional bin
Note: The stacker or stapler/stacker LED
blinks in amber.
The stacker or stapler/stacker output bin is
in the raised position.
1 Lower the output bin.
2 If this error persists, replace the stacker
or stapler/stacker.
MANUALLY FEED
<TYPE> <SIZE>
For help press
alternates with
A job was sent that requires a specific
paper type and size that is not currently
available.
1
Press
( H ELP button) for detailed
information.
2
Press
(U P A RROW button) and
(D OWN A RROW button) to step through
the instructions.
3 If the requested paper size and type is
installed in one of the trays, print a
Table 7-6 Alphabetical printer messages (continued)
Display-message troubleshooting 339