User Guide

Table 7-30 Curl or wave
Possible cause Recommended action(s)
The media does not meet
specifications or is not stored correctly.
1 Turn over the stack of media in the
tray. Also try rotating the media
180°.
2 Check the media for type and
quality. Replace the media if it
does not meet specifications, and
advise the customer to use the HP-
recommended media and to store
it correctly. See Media
specifications.
The operating environment does not
meet specifications.
Make sure that the printer is installed in
an area that meets the environmental
specifications. See
Operating
environment.
The wrong output bin is in use. Print to a different output bin (top or
rear output bin).
(Continued)
The fuser setting is incorrect for the
media type.
Open the configure-device menu at the
control panel, and change the fuser-
mode setting or select another media
type. See
Configure-device menu.
1
Press
(S ELECT button) or the
M
ENU button to open the menus.
2
Use
(U P A RROW button) or
(D OWN A RROW button to scroll to
CONFIGURATION, and then press
.
3
Use
or to scroll to PRINT
QUALITY, and then press
.
4
Use
or to scroll to FUSER
MODES, and then press
.
5
Use
or to scroll to the
submenu item that you want, and
then press
.
6 Press the P
AUSE /R ESUME button or
the M
ENU button to close the menu.
Image-formation troubleshooting 393