Owner manual

6 Remove the SIMM from the antistatic
package while avoiding touching the
metal contacts.
7 Hold the SIMM so the notch on one
end is on the bottom and the metal
contacts face toward the slot.
8 Hold the SIMM at a 30 degree angle
to the first available slot from the
right. Push the edge of the board
evenly and firmly into the slot (D).
Rotate the SIMM to the right (E) until
the board snaps into the locking tabs.
Repeat steps 6, 7, and 8 for each
SIMM being installed.
9 Replace the side panel by lining up
the alignment arrows (F) and sliding
the panel backwards (G) until the
release button latches into place (H).
Close the top cover.
10 Reinstall the interface cable(s) and
power cord. Turn the printer on.
Continue on the following page.
D
Memory Installation
EN Memory Installation D-3