Owner manual

Attaching a Parallel Printer Cable
To ensure reliability use an IEEE-1284
compliant parallel cable (these cables are
clearly marked with “IEEE-1284”). Only
IEEE-1284 cables support all of the
printer’s advanced functions.
Caution
Make sure power is off.
1
Locate the interface cable door (A) at
the back of the printer. Pull the door
out using the finger tab for leverage.
2 If using a parallel cable with a large
B-type end, connect the cable into
port (B). Snap the wire clips in place
to secure the cable to the printer.
If using a parallel cable with a small
C-type end, connect the cable into
port (C).
The cables should install easily. If
installation is difficult, check the
cable orientation.
3 Replace the interface cable door
while allowing the cable to feed
through its appropriate hole.
4 Connect the other end of the cable to
the proper connector on the computer.
Go to Step 7. Attach the Power Cord,
on page 1-12.
1-10 Printer Setup EN