Owner manual

Attaching a Macintosh Printer Cable
You can directly connect the printer to a
Macintosh (or Macintosh-compatible)
computer using either a LocalTalk or
Macintosh serial cable.
Note
To connect the printer to a LocalTalk
Network, see Appendix C.
Caution
Make sure power is off.
1
Locate the interface cable door (A) at
the back of the printer.
2 Pull the door out using the finger tab
for leverage.
3 Plug the cable into the printer’s
LocalTalk port. If the cable does not
slip on easily, make sure the pin
orientation matches the illustration.
4 Replace the interface cable door
while allowing the cable to feed
through the top hole.
5 Connect the other end of the cable to
the proper connector on the computer.
1
Printer Setup
EN Printer Setup 1-11