Owner manual

Installing the DOS Printing Software
The DOS printing software consists of the Remote Control Panel (RCP).
The RCP enables you to change printer settings if the DOS software
application does not support the printer feature you want to use. See
page 2-18 for RCP instructions.
Each DOS software application also requires a separate printer driver.
Please contact your DOS application vendor to obtain a printer driver.
Note If you are waiting to receive a driver for the HP LaserJet 6P/6MP
printer, you can substitute a printer driver from another HP LaserJet
Printer (use the latest version available). These substitute drivers allow
you to use the HP LaserJet 6P/6MP printer but may not support all of
the printer’s features.
To install the DOS Remote Control Panel:
CD ROM Installation Instructions
1 Insert the CD into the CD ROM drive:
2 At the DOS prompt, type D: (this assumes that the CD ROM drive is D)
and press [Enter] on the computer keyboard .
3 At the D:> type INSTALL and press [Enter].
4 Follow the instructions on the computer screen.
The printer setup is complete!
Diskette Installation Instructions
1 Insert the diskette into the disk drive.
2 At the DOS prompt, type A: (this assumes that the disk drive is A) and
press [Enter] on the computer keyboard .
3 At the A:> type INSTALL and press [Enter].
4 Follow the instructions on the computer screen.
The printer setup is complete!
1
Printer Setup
EN Printer Setup 1-17