Owner manual

Button Usage
The printer has two buttons: [Job[Cancel] (A) and [Go] (B).
[Job[Cancel]
•Press [Job[Cancel] to cancel a job that the printer is currently printing. The
top status panel lights will cycle while the printer memory is being cleared,
and then return to a ready state (front light on). This may take a while,
depending on the size of the print job.
•If [Job[Cancel] is accidentally pushed, the job must be reprinted. There is
no undo function.
•If [Job[Cancel] is pushed when the printer is idle, the top panel status lights
will cycle, but nothing else will happen.
[Go]
•Press [Go] to resume printing when the printer is paused or when unprinted
data is still in the printer (Data [middle] and Ready [front] lights on).
•Press [Go] to print a demo page. The printer must be in the ready state
(front light on).
•Press [Go] to clear some printer errors (Error [back] light on).
Top panel buttons
Note Briefly press [Go] and [Job[Cancel] at the same time to print a self test.
See page 2-8 for self-test descriptions.
Figure 2-3
2
Printer Basics
EN Printer Basics 2-5