Owner manual

Loading Media into Tray 1
Tray 1 (multi-purpose) holds up to
100 sheets of paper or up to 10 envelopes.
1 Grasp Tray 1 by the two finger tabs
and pull the top down.
2 Pull out the plastic tray extender by
grasping the center finger tab. If the
media being loaded is longer than
9 inches (229 mm), also pull out the
wire tray extender.
3 Slide the paper width guide to the far
right side of the tray.
4 Place media into the tray (short-edge
in, print-side up). The media should
be flush left, under the tab on the left
paper guide.
5 Slide the paper width guide to the left
until it lightly touches the media
without bending it. Make sure the
media fits under the tab on the paper
width guide.
Note
Do not add media to Tray 1 while the
printer is printing. This could cause a
paper jam.
Tray 1 hint
• For letterhead orientation in Tray 1,
see page 3-11.
3
Printing Tasks
EN Printing Tasks 3-5