Owner manual

6 Move the subtray to the rear position
(C), aligning the tabs on the front
sides of the subtray with the rear
grooves. Press the subtray down until
it snaps into place (D).
Continue here if not using Legal paper
size.
7 Press the top of the paper length
guide toward the center of the tray.
The guide should detatch from the
tray.
8 Align the pointer on the left of the
guide (E) with the desired paper size.
Insert the two front side tabs into the
appropriate holes (F) and push back
on the guide to the upright position,
snapping the center tab into place (G).
9 Load up to 250 sheets of paper in the
tray. Keep the paper below the arrows
on the paper length guide (H) in the
rear of the tray. Make sure the paper
is flat in the tray at all four corners. If
needed, press on the clip lever (I) to
raise the front left metal holder (J) so
the paper will fit underneath.
10 Slide Tray 2 back into the printer.
3
Printing Tasks
EN Printing Tasks 3-7