User Guide

Residual-toner-feed assembly
Before proceeding, remove the following components:
●
Intermediate transfer belt (ITB). See
Intermediate transfer belt (ITB) on page 102.
●
Left cover. See
Left cover on page 115.
●
Rear cover. See
Rear cover on page 116.
●
Toner collection unit access door. See
Toner collection unit access door on page 117.
●
Right-rear cover. See
Right-rear cover on page 119.
●
Top cover. See
Top cover on page 121.
●
Toner cover. See the first step of
Residual toner full sensor on page 152.
Remove the residual-toner-feed assembly
1. Release one tab (callout 1) by pulling the tab up. If necessary, use a small, flat-blade screwdriver
to pull the tab up. Remove the shutter (callout 2), and then pull the spring (callout 3) off the
assembly.
NOTE: There might be a piece of transparent tape over the tab (callout 1). Remove the tape to
release the tab.
Figure 2-137 Remove the residual-toner-feed assembly (1 of 2)
3
1
2
190 Chapter 2 Removal and replacement ENWW