User Guide

Each component test can be performed once or repeatedly. If you select the Repeat option (at the end
of the menu), the test cycles the component on and off. This process continues for two minutes, and then
the test terminates.
NOTE: The front or side door interlocks must be defeated to run the component tests. Some tests may
require that the ITB and print cartridges be removed. The control panel display prompts you to remove
some or all cartridges during certain tests.
1. Press the Home button .
2. Open the following menus:
●
Administration
●
Troubleshooting
●
Diagnostic Tests
3. Press the Down arrow
to highlight the Component Test item, and then press the OK button.
4. Select the component test options for the test you want to run.
Table 3-23 Component tests (1 of 2)
Component test Component tested Comments
Transfer Motors M1 (ITB motor)
M2 (drum motor)
Drives the ITB motor and drum
motor together at a specified
speed for 5 seconds.
Belt Only M1 (ITB motor) Drives ITB drive motor at a
specified speed for 5 seconds.
Developer Motors M1 (ITB motor)
M3 (developer motor)
Drives the ITB motor at a
specified speed for 5 seconds.
Drives the developer motor at
a specified speed for 5
seconds (drives 3 times).
Cartridge Motors M1 (ITB motor)
M2 (drum motor)
Drives the ITB motor at a
specified speed for 5 seconds.
Drives the drum motor at a
specified speed for 5 seconds
(drives 3 times).
Fuser Motor M4 Drives the fuser motor at a
specified speed for 5 seconds.
Alienation Motor (cartridge) M6 (developer alienation motor) Drives the developer
disengagement motor and
engages or disengages the
developer (drives the motor
four times). If the home
position of the developer is not
commanded within 5 seconds,
the product brings the
developer to its home position.
ENWW
Tools for troubleshooting
315