User Guide

Table 3-41 Embedded Jetdirect (continued)
First level Second level Third level Fourth level Fifth level Values Description
Refresh Yes
No*
When viewing the ping test
results, this item updates the
ping test data with current
results. Select Yes to update
the data, or No to maintain the
existing data. However, a
refresh automatically occurs
when the menu times out or
you manually return to the
main menu.
Link Speed Auto*
10T Half
10T Full
100TX Half
100TX Full
100TX Auto
1000TX Full
The link speed and
communication mode of the
print server must match the
network. The available settings
depend on the product and
installed print server. Select
one of the following link
configuration settings:
If you change the link setting,
network communications with
the print server and network
product might be lost.
Auto: The print server uses
auto-negotiation to configure
itself with the highest link speed
and communication mode
allowed. If auto-negotiation
fails, either 100TX Half or
10T Half is set depending on
the detected link speed of the
hub/switch port. (A 1000T
half-duplex selection is not
supported.)
10T Half: 10 Mbps, half-
duplex operation.
10T Full: 10 Mbps, full-duplex
operation.
100TX Half: 100 Mbps, half-
duplex operation.
100TX Full: 100 Mbps, full-
duplex operation.
100TX Auto: Limits auto-
negotiation to a maximum link
speed of 100 Mbps.
1000T FULL: 1000 Mbps,
full-duplex operation.
400 Chapter 3 Solve problems ENWW