User Guide

Feed-speed control

The product adjusts the feed speed to obtain the best print quality depending on the type of print

media. The product prints at the speed corresponding to the print mode specified by the formatter.

Auto Sense mode Print mode Print

speed

Media

sensor

detection

Normal mode Normal 1/1 Yes

Light mode Light media 1 1/1 Yes

Heavy Mode Heavy media 1 2/3 Yes

Cardstock Mode Heavy media 3 1/3 No

Transparency Mode OHT 1/3 Yes

Transparency2 Mode OHT + higher fuser temp 1/3 Yes

Envelope Mode Envelope 2/3 No

Label Mode Label 1/3 No

Tough Mode Glossy film 1/3 Yes

Extra Heavy Mode Heavy media 2 1/3 Yes

Heavy Glossy Mode Glossy media 1 2/3 Yes

X-hvyglossymode Glossy media 2 1/3 Yes

Rough Mode Rough 2/3 No

Card Glossy Mode Glossy media 3 1/3 Yes

4mm trns Mode OHT + lower fuser temp 1/3 Yes

Light Rough Mode Light media 1 + fuser temp adjustments 1/1 Yes

Fusing and delivery block

The fusing-and-delivery block fuses the toner image onto the print media and delivers the printed page

to the output bin.

Loop control

The product controls the loop (slackness) of print media to prevent the defects of print quality and media

feed.

●

If the fuser sleeve rotates slower than the ITB, the paper loop increases and an image defect or

paper crease occurs.

●

If the fuser sleeve rotates faster than the ITB, the paper loop decreases and an image is stretched

because the toner image is not transferred to the paper correctly

ENWW

Pickup, feed, and delivery system