Owner manual

2. Adjust the paper-length and paper-width
guides by squeezing the adjustment latches
and sliding the guides to the size of the paper
being used.
3. Load paper into the tray. Check the paper to
verify the guides lightly touch the stack, but do
not bend it.
NOTE: To prevent jams, do not overfill the
tray. Be sure the top of the stack is below the
tray full indicator.
NOTE: If the tray is not adjusted correctly,
an error message might appear during
printing or the paper might jam.
4. Close the tray.
5. The control panel shows the tray’s paper type
and size. If the configuration is not correct,
follow the instructions on the control panel to
change the size or type.
96 Chapter 6 Paper and print media ENWW