User Guide

8. After the alignment operation is complete, the stapler/stacker controller turns on the stamp
solenoid and the stamp clamps against the paper, so that the paper on the jogger guide is not
pushed out by the following paper. At the same time, the stapler/stacker controller moves the
jogger guide and the leading end alignment roller to the waiting position.
Figure 1-76 Alignment complete
SL2102
SL2101
M2102
M2100
Leading end alignment roller
Jogger guide
Stamp
Alignment-alienation motor
Alignment-alienation solenoid
Stamp solenoid
Jogger motor
9. The stapler/stacker repeats the preceding steps until the last sheet of the job is fed.
10. When the last sheet of the job is fed, the stapler/stacker controller performs the stapling operation,
if the product is in the staple mode. Then, the stapler/stacker controller engages and rotates the
output upper roller and the output lower roller to feed the paper stack. If the product is in the stack
align mode, the stapler/stacker controller engages and rotates the output upper roller and the
output lower roller to feed the paper stack without stapling.
104 Chapter 1 Theory of operation ENWW