User Guide

HCI exit sensor (PS3301)
1. Open the HCI right door.
2. Use a small flat-blade screwdriver to lift the sensor lever (callout 2).
Figure 2-40 HCI exit sensor
1
2
3. Check the control-panel display for sensor response.
4. If there is no response, replace the crossing paper feed assembly.
Scanner sensor tests
Use these diagnostic tests to manually test the document feeder and scanner sensors.
This section lists the sensors available in the Scanner Tests menu.
The Scanner Tests screen shows the sensor name, sensor state (active or inactive), and the number of
times the sensor has been toggled (activated).
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Troubleshooting
●
Diagnostic Tests
●
Scanner Tests
●
Sensors
3. Touch the sensor name on the Scanner Tests screen to display a sensor location graphic on the
control-panel display.
ENWW
Tools for troubleshooting
181