User Guide

Recommended action
No action necessary.
Output Bin full
Description
The output bin is full and must be emptied for printing to continue.
Recommended action
1. Empty the bin to continue printing.
2. Make sure that the paper full sensor flag is not damaged and can freely move. If the sensor flag is
damaged, replace the top-cover assembly.
3. Make sure that the connector is fully seated on the sensor and connector J45 is fully seated on the
DC controller.
4. Use the Manual Sensor Test menu items to test the sensor functionality. If necessary, replace the
sensor (PS1).
Paperless mode
Description
This is a test mode used in manufacturing and should not be seen on a normally operating product.
Recommended action
Contact HP support for steps to resolve this condition.
Printing Engine Test...
Description
The product is printing an engine test page.
Recommended action
No action is necessary.
Printing stopped To continue, touch “OK”
Description
Time has expired on the print/stop test.
Recommended action
Press the OK button to continue.
388 Chapter 2 Solve problems ENWW