User Guide

2. Press the engine test-page button.
Figure 2-1 Locating the engine-test-page switch
The test page should have a series of horizontal lines. The test page prints from the last tray that the
product used to print, unless the product has been turned off and then turned on again since the most
recent print job. If the product has been turned off and then on again since the most recent print job,
then the page will print from Tray 2. The product continuously prints test pages as long as the test-page
switch is depressed. The product will not print a test page if it is in Sleep mode.
Print formatter test pages
If the engine test was successful with the formatter removed, reinstall the formatter and then print a
configuration page to test the functionality of the formatter.
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Troubleshooting
●
Print Quality Pages
●
Fuser Test Page
3. Touch the Print button.
84 Chapter 2 Solve problems ENWW