User Guide

Table 2-26 Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
Link Speed Auto* The link speed and
communication mode
of the print server
must match the
network. The
available settings
depend on the
product and installed
print server. Select
one of the following
link configuration
settings:
CAUTION: If you
change the link
setting, network
communications with
the print server and
network product
might be lost.
The print server uses
auto-negotiation to
configure itself with
the highest link
speed and
communication mode
allowed. If auto-
negotiation fails,
either the 100TX Half
feature or the 10T
Half feature is set
depending on the
detected link speed
of the hub/switch
port. (A 1000T half-
duplex selection is
not supported.)
10T Half 10 Mbps, half-
duplex operation.
10T Full 10 Mbps, full-duplex
operation.
10T Auto 100 Mbps, half-
duplex operation.
100TX Half 100 Mbps, full-
duplex operation.
192 Chapter 2 Solve problems ENWW