User Guide

Recommended action
◦
Install new supplies.
◦
If you believe you purchased a genuine HP supply, go to
www.hp.com/go/anticounterfeit. Any
repair required as a result of using used cartridges is not covered under warranty. Supply status
and features depending on supply status are not available.
Used supply installed To continue, touch “OK”
Description
The product displays this message when a used supply (a remanufactured or refilled genuine HP or
non-HP product) has been installed.
◦
10.00.34 (event code): Black toner cartridge
Recommended action
◦
Install new supplies.
◦
If you believe you purchased a genuine HP supply, go to
www.hp.com/go/anticounterfeit. Any
repair required as a result of using used cartridges is not covered under warranty. Supply status
and features depending on supply status are not available.
Warming up scanner
Description
The scanner is warming up.
Recommended action
The product will enter the ready state when it is finished warming up.
Wireless Configuration Mode
Description
A USB wireless networking accessory was installed and is ready for configuration.
Recommended action
HP recommends using a computer and internet browser to configure this accessory. Enter the IP address
into an internet browser to access the full range of configuration options. After wireless functionality has
been configured and the changes have been applied, turn the product off and then on to exit the
Wireless Configuration Mode.
Wireless is not configured
Description
A USB wireless networking accessory was attached to the product and was not configured.
ENWW
Tools for troubleshooting
263