User Guide

USB storage device (control-panel menu)
NOTE: The USB port might be disabled by default. If necessary, use the control-panel menus to
enable the USB port.
1. Copy the xxxxxxx.bdl file to a portable USB flash drive.
2. Turn the product on, and then wait until it reaches the Ready state.
3. From the Home screen on the product control panel, scroll to and touch the Device Maintenance
button.
4. Touch the USB Firmware Upgrade button.
5. Insert the portable USB storage device with the xxxxxxx.bdl file on it into the USB port on the
front of the product, and then touch the OK button.
6. Touch the xxxxxxx.bdl file, and then touch the Upgrade button.
TIP: If there is more than one xxxxxxx.bdl file on the storage device, make sure that you
select the correct file for this product.
7. When the product prompts you to confirm the upgrade, touch the Upgrade button.
When the upgrade is complete, the product will initialize.
NOTE: The upgrade process can take up to 10 minutes to complete.
8. When the upgrade process is complete, print a configuration page and verify that the upgrade
firmware version was installed.
346 Chapter 2 Solve problems ENWW