User Guide

Table 2-45 Network Settings menu
First level Values Description
I/O Timeout Range: 5 – 300 sec
Default = 15
Use to set the I/O timeout period in seconds.
I/O timeout refers to the elapsed time before
a print job fails. If the stream of data that the
product receives for a print job gets
interrupted, this setting indicates how long
the product will wait before it reports that the
job has failed.
Jetdirect Menu See the table that follows for details. These
menus have the same structure. If an
additional HP Jetdirect network card is
installed in the EIO slot, then both menus are
available.
Table 2-46 Jetdirect Menu
First level Second level Third level Fourth level Values Description
Information Print Sec Report Yes
No*
Yes: Prints a page
that contains the
current security
settings on the
HP Jetdirect print
server.
No: A security
settings page is not
printed.
TCP/IP Enable On*
Off
On: Enable the TCP/
IP protocol.
Off: Disable the
TCP/IP protocol.
Host Name Use the arrow
buttons to edit the
host name.
NPIXXXXXX*
An alphanumeric
string, up to 32
characters, used to
identify the product.
This name is listed on
the HP Jetdirect
configuration page.
The default host
name is NPIxxxxxx,
where xxxxxx is the
last six digits of the
LAN hardware
(MAC) address.
ENWW
Tools for troubleshooting
195