Instruction Manual

2. Move the output device away from the MFP.
Figure 12-21 Clear jams in the stacker or stapler/stacker (2 of 7)
3. On the stacker, lift the wire on the lower bin of the device, and carefully pull out any media from
this area. On the stapler/stacker, carefully pull out any media that might be protruding from the
accumulator area.
NOTE: Only the stacker has the wire on the lower bin.
Figure 12-22 Clear jams in the stacker or stapler/stacker (3 of 7)
4. Locate the green handle in the flipper area and lift the handle.
Figure 12-23 Clear jams in the stacker or stapler/stacker (4 of 7)
5. Carefully pull out any media from the flipper area.
Figure 12-24 Clear jams in the stacker or stapler/stacker (5 of 7)
WARNING! Avoid touching the flipper area. It can be hot.
190 Chapter 12 Problem solve ENWW