User's Manual

Fax from the document feeder
1. Insert the originals into the document feeder
face-up.
NOTE: The document feeder capacity is up
to 35 sheets of 75 g/m
2
or 20 lb media.
CAUTION: To prevent damage to the
product, do not use an original that contains
correction tape, correction fluid, paper clips,
or staples. Also, do not load photographs,
small originals, or fragile originals into the
document feeder.
2. Adjust the guides until they are snug against
the paper.
3. Press the Setup button.
4. Select the Phone Book menu, and then press
the OK button.
5. From the list, select the phone book entry. If no
entry exists, use the keypad on the control
panel to dial the number.
6. On the control panel, press the Send Fax
button. The product starts the fax job.
Manual dial faxing
Usually, the product dials after you press the Send Fax button. At times, however, you might want
the product to dial each number as you press it. For example, if you are charging your fax call to a
calling card, you might need to dial the fax number, wait for the acceptance tone of your telephone
128 Chapter 10 Fax (M1210 Series only) ENWW