User's Manual

Connect to a network (M1210 Series only)
Supported network protocols
To connect a networking-equipped product to your network, you need a network that uses the following
protocol.
●
Functional wired TCP/IP network
Install the product on a wired network
You can install the product on a network by using the product CD. Before you begin the installation
process, do the following:
1. Connect the CAT-5 Ethernet cable to an available port on the Ethernet hub or router. Do not
connect the cable to an uplink port on the hub or router.
2. Connect the Ethernet cable to the Ethernet port on the back of the product.
3. Verify that one of the network lights (10 or 100) is illuminated on the network port located on the
back of the product.
CD installation on a wired network
NOTE: When you use the CD to install the software, you can select the Easy Install (recommended) or
the Advanced Install (you are prompted to accept or make changes to defaults) installation type.
1. Insert the software installation CD into the computer CD drive.
2. If the installation program does not open automatically, browse the CD contents and run the
SETUP.EXE file.
3. Follow the on-screen instructions for setting up the product and installing the software.
NOTE: Make sure that you select Connect via the Network when prompted.
42 Chapter 5 Connect the product ENWW