Operation Manual

Internal assemblies 101

Fuser assembly

1 Remove the left side, back, right side, and top covers (see pages

80 through 87).

2 Remove two screws (callout 1) from the right fuser plate.

3 Remove a third screw (callout 2) from behind the large gear on

the right fuser plate.

Note You can access the third screw through the holes in the 69Tgear.

If you need to realign the 69T gear, you must first remove the pressure

roller gear. Release the tab (callout 3) and remove the pressure roller

gear from the printer.

4 Remove the bracket.

Figure 45. Removing the fuser assembly (1 of 4)