Operation Manual

106 Chapter 5 - Removal and replacement
EN
Face-up roller
1 Turn the fuser assembly over.
2 Remove the gear (callout 1) from the face-up roller and release
the tab (callout 2) on the face-up roller bushing.
3 Rotate the face-up roller bushing forward until the pin releases.
4 Slide the face-up roller away from the gear side, and lift it out of
the fuser assembly.
Figure 50. Removing the output rollers (2 of 2)
Reinstall note
Flex the face-up roller bushing to pop the pin back into place.
2
2
2
1