Operation Manual

Control panel message Description Recommended action
MANUALLY FEED
OUTPUT STACK
alternates with
Then press
to
print second sides
The first side of a manual duplex job has
been printed and the device is waiting
for you to insert the output stack to
complete the second side.
1. Load the output stack into tray 1,
maintaining the same orientation
with printed side down.
2.
To continue printing, press
(S ELECT button) to exit the printer
message and then press
(S ELECT
button) to print.
MANUALLY FEED
[TYPE][SIZE]
To use another
tray press
The printer is waiting for media to be
loaded in tray 1 for manual feed.
Press (S ELECT button) to use a type
and size that are available in another tray.
MANUALLY FEED
[TYPE][SIZE]
To continue press
alternates with
MANUALLY FEED
[TYPE][SIZE]
For help press
The printer is waiting for media to be
loaded in tray 1 for manual feed.
Load the requested media into tray 1
and press
(S ELECT button).
No job to cancel The S TOP button was pressed, but there
is no active job or buffered data to cancel.
The message is displayed for
approximately 2 seconds before the
printer returns to the ready state.
No action necessary.
NON HP SUPPLY
INSTALLED
alternates with
<Current status message>
Economode disabled
The printer has detected that the print
cartridge is not a genuine HP supply.
This message is displayed until you
install an HP cartridge or press the
override button
(S ELECT button).
If you believe you purchased a genuine
HP supply, go to http://www.hp.com/go/
anticounterfeit.
Any printer repair required as a result of
using non-HP supplies or unauthorized
supplies is not covered under the printer
warranty.
ORDER CARTRIDGE
alternates with
<current status
message>
The message first appears when about
16% (6,000-page cartridge) or about 8%
(12,000-page cartridge) of the life
remains in the print cartridge.
Make sure that you have a new cartridge
ready (see
Ordering parts, accessories,
and supplies).
Paused
alternates with
To return to ready
press STOP
The printer is paused but continues to
receive data until the memory is full. The
printer is not experiencing an error.
Press S TOP .
Interpreting control-panel messages (continued)
ENWW Understanding printer messages 119