Operation Manual

Control panel message Description Recommended action
RAM DISK DEVICE
FAILURE
alternates with
<Current status message>
The RAM disk had a critical failure and
can no longer be used.
Contact an HP-authorized service or
support provider.
RAM DISK FILE
OPERATION FAILED
alternates with
<Current status message>
The requested operation could not be
performed. You might have attempted
an illegal operation, such as trying to
download a file to a non existent folder.
Try printing again to an existing folder.
RAM DISK FILE
SYSTEM IS FULL
alternates with
<Current status message>
The RAM disk is full. 1. Delete files and then try again, or
turn the printer power off, and then
turn the printer power on to delete
all files on the device. (Use Device
Storage Manager in HP Web
Jetadmin or another software utility
to delete the files.
2. If the message persists, increase
the size of the RAM disk. Change
the RAM disk size on the System
Setup submenu (on the Configure
Device menu) at the printer control
panel. See the description of the
RAM disk menu items in System
Setup submenu.
RAM DISK IS
WRITE PROTECTED
alternates with
<Current status message>
The RAM disk is protected, and no new
files can be written to it.
Use the Device Storage Manager in
HP Web Jetadmin to disable the write
protection.
RAM DISK NOT
INITIALIZED
alternates with
<Current status message>
The file system has not been initialized. Use HP Web Jetadmin to initialize the
file system.
REPLACE CARTRIDGE
To continue press
Pages remaining for this supply has
reached the low threshold. The printer
was set to continue printing when a
supply needs to be ordered.
Press (S ELECT button) to continue
printing the current job.
Follow the next steps to replace the
supply.
1. Open the top cover.
2. Remove print cartridge.
3. Install new print cartridge.
4. Close the top cover.
Interpreting control-panel messages (continued)
120 Chapter 4 Problem solving ENWW