Operation Manual
Selecting print media
This printer accepts a variety of media, such as cut-sheet paper, including up to 100%
recycled fiber content paper; envelopes; labels; transparencies; and custom-size paper.
Properties such as weight, composition, grain, and moisture content are important factors
that affect printer performance and output quality. Paper that does not meet the guidelines
that are outlined in this manual can cause the following problems:
● Poor print quality
● Increased jams
● Premature wear on the printer, requiring repair
NOTE
Some paper might meet all of the guidelines in this manual and still not produce satisfactory
results. This might be the result of improper handling, unacceptable temperature and
humidity levels, or other variables over which Hewlett-Packard has no control. Before
purchasing large quantities of media, make sure that it meets the requirements that are
specified in this User guide and in the HP LaserJet Printer Family Print Media Guide, which
is available for download at http://www.hp.com/support/ljpaperguide. Always test paper
before buying large quantities.
CAUTION
Using media that does not meet HP specifications can cause problems for the printer,
requiring repair. This repair is not covered by the HP warranty or service agreements.
Supported types and sizes of print media
Tray 1
Dimensions
1
Weight
Capacity
2
Minimum size (custom) 76 x 127 mm
(3 x 5 inches)
60 to 199 g/m
2
(16 to 53 lb)
100 sheets of 75 g/m
2
(20 lb) paper
Maximum size (custom) 216 x 356 mm
(8.5 x 14 inches)
Transparency Same as minimum
and maximum paper
sizes listed above.
Thickness: 0.10
to 0.14 mm (0.0039 to
0.0055 inch)
75 typical
Labels
3
Thickness:
0.10 to 0.14 mm
(0.0039 to 0.005 inch)
50 typical
Envelopes
Up to 90 g/m
2
(16 to 24 lb)
Up to 10
1
The printer supports a wide range of sizes. See the printer software for supported sizes. To
print on custom-size paper see
Printing on custom-sized media or cardstock.
2
Capacity can vary depending on media weight and thickness, as well as environmental
conditions.
3
Smoothness: 100 to 250 (Sheffield).
34 Chapter 1 Printer basics ENWW