Operation Manual

4. Place media into the tray (short-edge in, print-side up). The media should be centered
between the media-width guides and under the tabs on the media-width guides.
5. Slide the media-width guides inward until they lightly touch the media stack on both
sides without bending it. Make sure that the media fits under the tabs on the media-width
guides.
NOTE
Do not add media to tray 1 while the printer is printing. This could cause a jam. Do not close
the front door when the printer is printing.
Loading tray 2 (250-sheet tray)
Tray 2 supports only paper (A4, A5, B5 JIS, Letter, Legal, Executive, and 8.5 x 13 inches).
To load tray 2
1. Pull the tray out of the printer and remove any paper.
ENWW Loading trays 43