Owner's manual

TIP: Try to avoid wrinkling by using substrates that do not wrinkle, or by using a slower print mode
that will allow you to lower the drying and curing power.
●
The ink collector install position is used only for installing the ink collector kit (see The ink collector kit
on page 32); it is not used for printing.
To set the carriage beam position, go to the Internal Print Server and select the appropriate position from the
drop-down list.
WARNING! Keep away from the printer's moving parts until the carriage beam has reached its new position.
CAUTION: Do not change the carriage beam position while the printhead cleaning roll is out of place.
76 Chapter 3 Handle the substrate ENWW