Owner manual

You can use the front panel to adjust the following settings while printing.
●
To change temperature, vacuum, inter-pass delay offset, and substrate-advance settings while
printing, press Adjustments in the front panel’s print job screen, and choose the setting that you want
to adjust. The changes that you make take effect immediately, but they are not saved: the next job will
use the settings in the substrate preset as usual.
You can use the Save button to save settings, and the Reset button to restore the last saved settings.
NOTE: The Save button is not available for a generic or non-editable preset.
●
To change substrate advance calibration while printing (in case of banding): press Adjustments >
Advance factor. The changes that you make take effect immediately, but they are not saved for the
next job. See also
Substrate advance adjustment while printing on page 111.
To make permanent substrate-advance changes, use the RIP or front panel to modify the substrate
preset.
Temperature profile
Many of the main and advanced substrate settings are related to temperature control, since this is a critical
area for correct printing results with latex inks on a wide variety of substrates.
NOTE: There is a delay between making a change and seeing the results. See the front panel for actual
temperature checking.
NOTE: If you selected English units of measurement, you may notice some discrepancies, as the printer
works in Celsius and makes the conversion.
Select the number of passes
Increasing the number of passes will tend to improve the print quality but reduce the speed of printing.
NOTE: The following table is for the normal ink limit unless otherwise indicated.
Category Substrate name Available print modes
Banner Generic PVC Banner 4p_4C_80 6p_6C_100 10p_6C_110
Generic Backlit PVC Banner 12p_6C_200 16p_6C_200 20p_6C_200
Self-adhesive vinyl Generic Self-Adhesive Vinyl 6p_4C_80 8p_6C_100 10p_6C_110
Generic Backlit Self-Adhesive Vinyl 12p_6C_130 16p_6C_150 20p_6C_200
Paper Generic Paper 6p_4C_80 8p_6C_100 10p_6C_110
Generic Coated Paper 8p_6C_90 10p_6C_100
ENWW Add a new substrate 95