- Hewlett-Packard Car Video System User Manual
Table Of Contents
- Product Features
- Safety and Maintenance Guidelines
- Setting Up the Monitor
- Unfolding the Double-Hinged Monitor Pedestal Base
- Unfolding the Single-Hinged Monitor Pedestal Base
- Rear Components
- Cable Management
- Connecting the Cables
- Adjusting the Monitor
- Turning on the Monitor
- Connecting USB Devices
- Using the Accessory Rails
- Removing the Monitor Pedestal Base
- Locating the Rating Labels
- Operating the Monitor
- Troubleshooting
- Technical Specifications
- Agency Regulatory Notices
- LCD Monitor Quality and Pixel Policy
4. Connect one end of the provided USB cable to the USB hub connector on the rear panel of the
computer, and the other end to the upstream USB connector on the monitor (on select models).
Figure 3-8 Connecting the USB Cable
WARNING! To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one may
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the
electrical outlet, grasp the cord by the plug.
Connecting the Cables 11