HP ProLiant ML150 Lights-Out 100 Remote Management Card Installation Instructions

HP Lights-Out 100
Remote Management
Card
Installation Instructions
for HP ProLiant ML150
Generation 2 Servers
Read instructions completely before beginning
installation procedure.
© Copyright 2004 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should be
construed as constituting an additional warranty. HP shall not be liable for technical
or editorial errors or omissions contained herein.
HP Lights-Out 100 Remote Management Card Installation Instructions
First Edition (July 2004)
Part Number 372036-021
Overview
This document contains instructions for installing an HP ProLiant
ML150 Generation 2 Lights-Out 100 remote management card
into an HP ProLiant ML150 G2 server.
NOTE: For more information on preparing the server for installation, refer
to the user guide included on the Support CD.
Kit Contents
• HP ProLiant ML150 G2 Lights-Out 100 remote management
card
• Hexnut screw
• This document
Important Safety Information
Refer to the Important Safety Information document included with
the server.
CAUTION: Electrostatic discharge (ESD) can damage electronic
components. Be sure you are properly grounded (earthed) before
beginning any installation procedure.
Installation Guidelines
This installation is to be performed by qualified individuals who
are knowledgeable of the procedures, precautions, and hazards
associated with equipment containing hazardous energy circuits.
Card Connector Location
Item Description
1 HP ProLiant ML150 G2 Lights-Out 100 remote
management card connector