Service manual

Chapter 4 Diagnostics
44
To clear the configuration:
1. Turn off power to the Netserver and remove the cover.
2. Move switch 4 in the configuration switch on the system board (labeled "Clear CMOS") to the
ON position.
3. Turn on power to the Netserver.
A message displays indicating the configuration has been cleared.
4. Turn off power to the Netserver.
5. Return switch 4 on the system board to the OFF position.
6. Replace the cover.
7. Turn on power to the Netserver and the following message displays:
Incorrect System Configuration
8. Press [F2] to run the Setup Utility when <F2=Setup> appears.
9. Make any configuration changes required.
10. Choose the Exit option and save the changes to save the configuration and exit the Setup
Utility.
Configuration Switch
Spring Latch Battery
Switch 1 Positio
n
Configuration Switch Location
Clear CMOS
Clear Password
Open
Shaded rectangle
represents the position
of switch.
Open = Off Closed = On
Not Used (Default = Off)
Not Used (Default = Off)
Rear of Chassis
BIOS Recovery
Configuration Switch Positions