RAID User Guide

5 RAID volume setup
NOTE: If your system has Intel® Smart Response Technology, please see Intel Rapid Storage
Technology on page 10 before setting up RAID volumes.
The following instructions assume that a supported hard drive is installed in the computer Upgrade
Bay, in the SATA-swappable bay of the docking station, or connected to the eSATA port of the
computer (see
Devices supported on page 7).
The basic RAID migration steps are as follows:
●
Enable RAID through the Computer Setup (BIOS).
●
Initiate RAID migration using Intel® Rapid Storage Technology Console.
CAUTION: Make sure that the computer is connected to AC power before initiating the following
procedures. The loss of power during RAID migration can result in the loss of data.
14 Chapter 5 RAID volume setup