HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

Technical Newsletter | HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

2) In some networks, you also need to add the domain name to the hostname in order to identify the device. You can get

the domain name from the connectivity application on the device’s front panel by going to:

Settings > Connectivity > Network > Gigabit Ethernet > Network Identification > Domain Name.

The device’s final name in said case will be “hostname.domainName.”

Create a PrintOS account

If you already have a PrintOS account, you can ignore this section.

To create a new customer PrintOS account:

1) In Command Center Client, go to Settings > Device Management > Add device.

Note: If the button is disabled, check your connection to the Command Center Server: Open the notifications center, as

you should see a notification informing you of the problem.

2) Click Create account:

3) You will be redirected to a PrintOS page in your browser. You’ll need to register with your information and enter the

serial number of one of your devices. Then you will receive an email invitation to log in using your new account.

Afterwards you’ll need to accept the terms & conditions in order to enable it.