Specifications

Solid-state drive

Description Spare part number

32-GB solid-state drive 718444-001

Before removing the solid-state drive, follow these steps:

1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by unplugging the power cord from the computer.

3. Disconnect all external devices from the computer.

Remove the battery (see

Battery on page 30).

5. Remove the hard drive service cover (see

Hard drive on page 31).

Remove the solid-state drive:

1. Remove the Phillips PM2.0×2.0 screw (1) that secures the solid-state drive to the system board.

(The solid-state drive tilts up.)

2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.

Reverse this procedure to install the solid-state drive.

Component replacement procedures