Upgrade and Service Guide

Upgrading and Servicing Guide 3
Replacing the Side Panel
1 Slide the side panel forward on the frame until it
locks into place.
2 Align the thumbscrews on the side panel with the
holes on the back of the chassis frame, and then
tighten the thumbscrews on the side panel.
3 See “After Closing the PC” on page 2.
Removing the Front Panel
This procedure is necessary only when removing or
replacing an optical drive, a memory card reader, or
a hard disk drive.
1 Locate the three small tabs attached to the front
panel on the side of the chassis.
2 Press each tab away from the center of the chassis.
Press the top, the middle, and the bottom tab, and
then gently remove the front panel.
Replacing the Front Panel
1 Place the chassis upright, and then align the three
tabs on the right side of the front panel with the
correct holes on the chassis.
2 Guide the three small tabs on the left side of the
front panel into the correct holes until the panel
snaps into place.