Mellanox MLNX-OS Release Notes for SX1018HP Ethernet Managed Blade Switch

Mellanox Technologies

4. LAG The remote LACP admin-key #1 cannot be estab-

lished with some third party vendors.

Use a different admin-key

number.

5. LAG Traffic running over LAG may not be evenly dis-

tributed when testing small number of SMACs.

6. LAG A port-channel stops forwarding traffic after dis-

abling some Ethernet ports in the same port-chan-

nel group.

Disable and enable the

LAG.

7. LAG When converting static LAG to dynamic LAG

(LACP), some of the ports remain in ‘DOWN’

state.

Disable and enable the

LAG.

8. VLAN It might take approximately 20 seconds to create/

delete 1000 VLANs, or to change the switchport

mode of an interface.

9. Spanning Tree Non-standard behavior may occur on third party

switch STP functionality when the port moves

from Root to Alternate state. The standard Pro-

posal-Agreement sent by MLNX-OS is unan-

swered which may result in traffic loss of up to 30

seconds.

10. IGMP Snooping Setting the “ip igmp snooping unregistered multi-

cast” option to “forward-to-mrouter-ports” option

reduces the amount of supported VLANs to 250.

11. ACL A mask of IPv4 ACL rule can contain either 255

or 0 in any of the 4 bytes assembling it.

12. ACL ACL is not supported on split interfaces.

13. ACL Removing configured ACL on split interfaces

requires reset factory.

Index Category Description Possible Workaround