Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed Blade Switch

Rev 2.10
Mellanox Technologies
144
Mellanox Technologies Confidential
4.3.5 Commands
This chapter displays all the relevant commands used to manage the system software image.
Specifies the default location where the system should be booted from.
location ID Specifies the default destination location. There can be
up
to 2 images on the system. The possible values are 1
or 2.
next Sets the boot location to be the next once after the one
currentl
y booted from, thus avoiding a cycle through all
the available locations.
N/A
enable/config
3.1.0000
admin
switch (config) # image boot location 2
switch (config) #
show images
image boot
image boot {location <location ID> | next}
Syntax Description
Default
Configuration Mode
History
Role
Example
Related Commands
Note