Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed Blade Switch

Rev 2.10
Mellanox Technologies
219
Mellanox Technologies Confidential
4.7.2 SNMP Trap Notifications
To set SNMP notification see Section 4.13.1.6, “Configuring an SNMP Notification,” on
page 348.
4.7.3 Terminal Notifications
 To print events to the terminal:
Set the events you wish to print to the terminal. Run:
switch (config) # logging monitor events notice
This command prints system events in the severity “notice” to the screen. For example, in case of
interface-down event, the following gets printed to the screen.
switch (config) #
Wed Jul 10 11:30:42 2013: Interface IB1/17 changed state to DOWN
Wed Jul 10 11:30:43 2013: Interface IB1/18 changed state to DOWN
switch (config) #
new_root Local bridge became a
root bridge
Bridge-MIB:
newRoot
Supported for
Ethernet
paging-high Paging activity has risen
too hi
gh
N/A Not supported
power-redundancy-mismatch Power redundancy mis-
match
Mellanox-EFM-MIB:
powerRedundancy
Mis-
match
Supported for
SX65XX only 
systems
process-crash A process in the system
has crashed
Mellanox-EFM-MIB:
proc
Crash
process-exit A process in the system
unexpectedly exited
Mellanox-EFM-MIB:
procUnexpectedExit
snmp-authtrap An SNMPv3 request has
failed authentication
Not implemented
topology_change Topology change trig-
gered by a local bridge
Bridge-MIB: topolo-
gyChange
Supported for
Ethernet
unexpected-shutdown Unexpected system shut-
down
Mellanox-EFM-MIB:
unexp
ectedShut
down
To send, use the CLI com-
mand:
snmp-server
notify send-test
Send a testing event testTrap
N/A Reset occurred due to
over-heating of ASIC
Mellanox-EFM-MIB:
asicOverT
empReset
Not supported
temperature-too-high Temperature is too high Mellanox-EFM-MIB:
asicOverT
emp
Table 22 - Supported Event Notifications and MIB Mapping
Event Name Event Description MIB OID Comments