Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed Blade Switch

Rev 2.10
Mellanox Technologies
500
Mellanox Technologies Confidential
 To enable PFC per priority:
Step 1. Log in as admin.
Step 2. Enter config mode. Run:
Step 3. Enable PFC globally on the switch. Run:
Step 4. Choose the desirable priority you want to enable using the command dcb priority-flow-control
priority <pri[0..7]> enable .
 To enable PFC per interface:
Step 1. Log in as admin.
Step 2. Change to config mode. Run:
Step 3. Enable PFC globally on the switch. Run:
Step 4. Choose the desirable priority you want to enable using the command dcb priority-flow-control
priority <pri[0..7]> enable
Step 5. Change to Interface mode. Run:
Step 6. Enable PFC for the specific interface:
5.9.2 Enhanced Transmission Selection (ETS)
Enhanced Transmission Selection (ETS) provides a common management framework for assign-
ment of bandwidth to traffic classes, for weighted round robin (WRR) scheduling. If a traf
fic
class does not use all the bandwidth allocated to it, other traffic classes can use that available
bandwidth. This allows optimal utilization of the network capacity while prioritizing and provid-
ing the necessary resources.
The ETS feature has the following attributes:
• ETS global admin:
• Enable (default) – scheduling mode is WRR according to the configured bandwidth-per-
traf
fic class
switch > enable
switch # configure terminal
switch (config) # dcb priority-flow-control enable
# dcb priority-flow-control enable
This action might cause traffic loss while shutting down a port with priority-flow-con-
trol mode on
Type 'yes' to confirm enable pfc globally: yes
switch (config) #
switch (config) # dcb priority-flow-control priority 5 enable
switch > enable
switch # configure terminal
switch (config) # dcb priority-flow-control enable
switch (config) # dcb priority-flow-control 5 enable
switch (config) #
switch (config) # interface ethernet 1/1
switch (config interface ethernet 1/1) #
switch (config interface ethernet 1/1) # dcb priority-flow-control mode on