Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed Blade Switch

Rev 2.10
Mellanox Technologies
530
Mellanox Technologies Confidential
Step 7. Enable the session. Run:
5.11.3 Verifying Mirroring Sessions
 To verify the attributes of a specific mirroring session:
 To verify the attributes of running mirroring sessions:
If the option pause-excessive-frame is selected, make sure that flow control is
enabled on all source interfaces on the ingress direction of the monitoring session
using the command
flowcontrol in the interface configuration mode.
switch (config monitor session 1) # no shutdown
switch (config) # show monitor session 1
Admin: Enable
Status: Up
Truncate: Enable
Destination interface: eth1/2
Congestion type: pause-excessive-frames
Header format: add-ethernet-header
- traffic class 2
- vlan 10
- priority 5
- destination-mac 00:0d:ec:f1:a9:c8
Source interfaces
Interface direction
-------------------------
eth1/1 both
switch (config) # show monitor session summary
Session Admin Status Mode Destination Source
1 Enable Up add-eth eth1/2 eth1/1(b)
2 Disable Down add-vlan eth1/2 eth1/8(i), po1(e)
3 Enable Up add-eth eth1/5 eth1/18(e)
7 Disable Down local