Mellanox MLNX-OS® User Manualfor SX1018HP Ethernet Managed Blade Switch

Rev 1.6.9

Mellanox Technologies

Mellanox Technologies Confidential

Step 4. (Optional) Verify in-band management configuration. Run:

Step 5. 618orappropriate

4.2 Software Management

4.2.1 Upgrading MLNX-OS® Software

To upgrade MLNX-OS software on your system, perform the following steps:

Step 1. Change to Config mode.

Step 2. Obtain the previously available image (.img file). You must delete this image in the next step to

make room for fetching the new image.

switch (config) # show interfaces vlan10

Interface vlan10 status:

Comment:

Admin up: yes

Link up: yes

DHCP running: no

IP address: 10.10.10.10

Netmask: 255.255.255.0

IPv6 enabled: no

Speed: N/A

Duplex: N/A

Interface type: ethernet

Interface source: vlan

MTU: 1500

HW address: 00:02:C9:7E:24:E8

RX bytes: 0 TX bytes: 250

RX packets: 0 TX packets: 3

RX mcast packets: 0 TX discards: 0

RX discards: 0 TX errors: 0

RX errors: 0 TX overruns: 0

RX overruns: 0 TX carrier: 0

RX frame: 0 TX collisions: 0

TX queue len: 0

switch (config) #

When upgrading from a software version older than 3.2.0100 to software version

3.3.0000 or higher, the upgrade procedure must be done in two steps. First update the

software to 3.2.0300-100 (for InfiniBand platforms) or 3.2.0506 (for Ethernet plat-

forms), then update to the desired software version.

switch > enable

switch # configure terminal

switch (config) #

switch (config) # show images

Installed images: