Mellanox MLNX-OS® User Manualfor SX1018HP Ethernet Managed Blade Switch

Rev 1.6.9
Mellanox Technologies
42
Mellanox Technologies Confidential
4.2.2 Deleting Unused Images
 To delete unused images:
Step 1. Enter Config mode. Run:
Step 2. Get a list of the unused images. Run
Step 3. Delete the unused images. Run:
For further information, please refer to Mellanox MLNX-OS Command Reference Guide.
4.2.3 Downgrading MLNX-OS Software
Prior to downgrading software, please make sure the following prerequisites are met:
Step 1. Log into your switch via the CLI using the console port.
Step 2. Backup your configuration according to the following steps:
1. Change to Config mode. Run:
When performing upgrade from the WebUI, make sure that the image you are trying to
upgrade to is not located already in the system (i.e. fetched from the CLI).
switch >
switch > enable
switch # configure terminal
switch (config) # show images
Images available to be installed:
image-PPC_M460EX-SX_3.1.1224.img
SX-OS_PPC_M460EX SX_3.1.1224 2011-04-28 12:29:48 ppc
Installed images:
Partition 1:
SX-OS_PPC_M460EX 3.1.0000-dev-HA 2011-04-10 12:02:49 ppc
Partition 2:
SX-OS_PPC_M460EX 3.1.0000-dev-HA 2011-04-10 12:02:49 ppc
Last boot partition: 1
Next boot partition: 1
Boot manager password is set.
No image install currently in progress.
Require trusted signature in image being installed: yes
switch (config) #
switch config) # image delete image-PPC_M460EX-SX_3.0.1224.img
switch (config) #
switch-112094 [standalone: master] > enable
switch-112094 [standalone: master] # configure terminal
switch-112094 [standalone: master] (config) #